growthfactor66
New member
Looking for a simple answer please!
Enhanced Nation
Great to see you here. Join our insightful forum today and start tapping into a huge wealth of knowledge. Completing our simple registration process will allow you to gain access to exclusive content, add your own topics and posts, share your knowledge and connect with other members through your own private inbox! And don’t forget to say hi!
How do you mix peptides?
- Thread starter growthfactor66
- Start date
Grab some larger 23gauge syringes to draw the bacteria static water from its own vial into the peptide powder vials, but before you draw the water for prep,inject air into the peptide vials with the 23gauge syringes to relax the pressure in the vials but you don’t need much or the air will push the water back out stalling the syringe when trying to inject the water into the vial.
You have to do this otherwise the depression pulls the bacteria static water into the powder way too fast and destroys the peptide powders capabilities or weakens its effectiveness.
When you reconstitute your powders with the water hold the vials upside down so the water doesn’t flood directly onto the powder,just leak it into the vials slowly.
Here’s the example for dosages you’ll find on the Phoenix website… the
ull syring to’’’ are my own dosages so use the Peptide Calc to telly up the strength of effectiveness that you want to trial,I mix both my BPC&TB vials to 3ml of bacteria static water but that’s just my own preference.TB500
5mg of powder
2.5ml of bacteriostatic water
equals 2,000 mcg/ml
At time of dosing, an insulin syringe is used to draw and then inject the desired amount. In the above example a 2,000 mcg (or 2mg) dose would require 1 mL, or “100 IU” as marked on an insulin syringe.
The most common dosing protocol is to take 2.0 or 2.5 mg of TB-500 either once or up to twice per week for four to six weeks, and then reduce to a lower dosing rate thereafter
ull syringe to 90 for 1500mcgBPC157
5mg of powder
2.5ml of bacteriostatic water
equals 2,000 mcg / ml
At the time of dosing, an insulin syringe is used to draw and then inject the desired amount.
In the above example, a 200 mcg dose would require only 0.1 mL, or “5 IU” as marked on an insulin syringe.
A 300 mcg dose would require 0.15 mL, or “15 IU” as marked on an insulin syringe.
Dosing for BPC-157 would typically be 200 – 400 mcg per day, 4 weeks on, 2 weeks off for wound repair and injury recovery.
ull syringe to 10 for 250mcgCheck out the Phoenix peps website for their recommendations on mixing and dosages.
Good luck out there!